SEN00585-00 30 Testing and adjusting Adjusting fuel control dial and decelerator pedal 1 2. Preparatory work 1) Start the engine, set the monitor panel in the “Adjustment mode“, and prepare to measure the engine speed. a For the operation method, see “Spe- cial functions of monitor panel (EMMS)”. 1. Outline of fuel control system q The following signals are inputted as rota- tion command signals to the engine con- troller. q Decelerator pedal potentiometer sig- nal q Adjustment code : 0007 (Engine deceleration cut mode) a The engine speed is displayed by 1 rpm.
q 3rd throttle signal The engine controller controls the fuel control system of the engine (CRI system) according to the lowest engine speed sig- nal among those input signals. q Adjust the deceleration slow speed by adjusting the decelerator pedal linkage. [1] Fuel control dial [2] Engine controller [3] Steering and transmission controller [4] Decelerator pedal [5] Decelerator potentiometer [6] Engine (CRI system) [7] 3rd throttle signal [8] Rod 32 D65EX, PX, WX-15E0