SEN00587-00 30 Testing and adjusting 2. Contents of CPU LED displays a The LED displays should be checked with the starting switch ON, starting switch START, or with the engine started. a Type and time of blinking Fast blinking: blinking on an approximately 1 second cycle Slow blinking: blinking on an approximately 4 second cycle a The LED displays can be checked in “monitoring mode” of the monitor panel. 3. Contents of 7-segment LED displays for CPU a The LED displays should be checked with the starting switch ON. * It may take more than 1 minute from turning on the starting switch to the completion of positioning even in an outdoor place where radio wave can reach.
Positioning is impossible in areas with extremely weak radio waves or areas beyond the reach of radio waves. a The LED displays can be checked in “monitoring mode” of the monitor panel. 26 D65EX, PX, WX-15E0 No. LED Name, Function Display Contents of display 6 LED-C1 Starting switch ACC signal status and alternator R signal status ON Starting switch ACC signal: ON, alternator R signal: ON Fast blinking Starting switch ACC signal: OFF, alternator R signal: ON Slow blinking Starting switch ACC signal: ON, alternator R signal: OFF OFF Starting switch ACC signal: OFF, alternator R signal: OFF 7 LED-C2 Engine control signal status ON Engine control signal: ON OFF Engine control signal:
OFF 8 LED-C3 S-NET connection status and starting switch C signal sta- tus ON S-NET: connected, starting switch C signal: OFF Fast blinking Starting switch C signal: ON Slow blinking (Not used) OFF S-NET: unconnected, starting switch C signal: OFF 9 LED-C4 CAN connection status ON CAN: active (fuel sensor: no communication) Fast blinking CAN: active (fuel sensor: in communication) Slow blinking CAN: inactive (fuel sensor: in communication) OFF CAN: inactive (fuel sensor: no communication) 10 LED-C5 Downloading and writing status Either one is ON Downloading and writing status (special function for system administrator) 11 LED-C6 Both are OFF Normal operation mode No.
LED Name, Function Display Contents of display 12 7-segment Number of unsent mails 0 – 9 Number of unsent mails 13 Dot GPS positioning status ON GPS positioning has been completed. (Position has been recog- nized. Refer to [*].) OFF GPS positioning has not been completed. (Position has not been recognized. Refer to [*].)