SEN00589-00 40 Troubleshooting Failure code [15SEL1] 1st clutch: Fill signal is ON when command current is OFF 1 Circuit diagram related to transmission 1st clutch ECMV 24 D65EX, PX, WX-15E0 Action code Failure code Failure symptom 1st clutch: Fill signal is ON when command current is OFF (Steering and transmission controller system) CALL E03 15SEL1 Failure conte • The fill switch signal does not become off when the output of the transmission 1st clutch solenoid cir- nt cuit has stopped. Controller's action • Flashes warning lamp and turns on alarm buzzer. • Limits operation of engine and transmission.
Symptoms th appears on machine at • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1 and R1. General information • The input state (ON/OFF) from the 1st clutch fill switch can be checked in monitoring mode. (Code 31520: Transmission fill switch input state) • Duplication of failure code:
Engine start + F1 or R1 o travel neutral Possible causes and th standard valu when norma Cause Defective 1st clutch 1 fill switch (internal short circuit) Defective harness grounding 2 e (Contact with ground circuit) es l Defective steering and 3 transmission controller Defective hydraulic pressure 4 system Standard value when normal and remarks for troubleshooting aPrepare with starting switch OFF, then start the engine for trou- bleshooting. 1SW (male) PCCS lever Resistance Between (1) – chassis ground Other than F1 and R1 Min. 1 Mz F1 and R1 Max. 1 z aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF.
Between ground and wiring harness between ST3 (female) (19) – 1SW (female) (1) Resis- M tance in. 1 Mz aPrepare with starting switch OFF, then start the engine for trou- bleshooting. ST3 PCCS lever Voltage Between (19) – chassis ground Other than F1 and R1 5 – 11 V F1 and R1 Max. 1 V When no fault is detected in the electric system, the hydraulic pres- sure system is assumed to be abnormal. Carry out the related trou- bleshooting (H-mode).