SEN00589-00 40 Troubleshooting Failure code [15SFL1] 2nd clutch: Fill signal is ON when command current is OFF 1 26 D65EX, PX, WX-15E0 Action code Failure code Failure symptom 2nd clutch: Fill signal is ON when command current is OFF (Steering and transmission controller system) CALL E03 15SFL1 Failure content • The fill switch signal does not become off when the output of the transmission 2nd clutch solenoid circuit has stopped. Controller's action • Flashes warning lamp and turns on alarm buzzer. • Limits operation of engine and transmission. Symptoms that appears on machine • The auto shift down function does not work. • Once machine is stopped, engine speed is limited to medium (half).
• Once machine is stopped, travel is limited to F2 and R2. General information • The input state (ON/OFF) from the 2nd clutch fill switch can be checked in monitoring mode. (Code 31520: Transmission fill switch input state) • Duplication of failure code: Engine start + F2 or R2 o travel neutral Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective 2nd clutch fill switch (internal short circuit) aPrepare with starting switch OFF, then start the engine for trou- bleshooting. 2SW (male) PCCS lever Resistance Between (1) – chassis ground Other than F2 and R2 Min. 1 Mz F2 and R2 Max.
1 z 2 Defective harness grounding (Contact with ground circuit) aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF. Between ground and wiring harness between ST3 (female) (29) – 2SW (female) (1) Resis- tance Min. 1 Mz 3 Defective steering and transmission controller aPrepare with starting switch OFF, then start the engine for trou- bleshooting. ST3 PCCS lever Voltage Between (29) – chassis ground Other than F2 and R2 5 – 11 V F2 and R2 Max. 1 V 4 Defective hydraulic pressure system When no fault is detected in the electric system, the hydraulic pres- sure system is assumed to be abnormal. Carry out the related trou- bleshooting (H-mode).