Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FAILURE CODE [CA131] DECELERATOR PEDAL SENSOR TOOL HIGH: EXCESSIVELY HIGH VOLTAGE DETECTED

SEN00589-00 40 Troubleshooting Failure code [CA131] Decelerator pedal sensor tool high: Excessively high voltage detected 1 42 D65EX, PX, WX-15E0 Action code Failure code Failure symptom Decelerator pedal sensor too high: Excessively high voltage detected (Engine controller system) CALL E03 CA131 Failure content • Excessively high voltage is detected at signal circuit of decelerator pedal. Controller's action • Operates with the fixed value that is same as the value just before the abnormality is detected, if abnormality occurs with the starting switch in the ON position.

• If the starting switch is turned to the ON position in the same abnormal condition, the controller oper- ates with 100% value. Symptoms that appears on machine • Engine speed cannot be controlled by decelerator pedal. General information • The signal voltage of decelerator pedal can be checked in monitoring mode. (Code: 31703 Decelerator voltage) • Duplication of failure code: turn ON the starting switch. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective throttle sensor power supply circuit If failure code [CA2185] is displayed at the same time, carry out troubleshooting for that first.

2 Defective decelerator pedal aPrepare with starting switch OFF, then start troubleshooting with starting switch ON. DCL Voltage Between (A) – (C) Power source 4.75 – 5.25 V Since voltage is measured with the harness connected, further diag- nose the harness and the controller if the voltage is not normal, and then make judgment after it is determined that there is no other defective cause. 3 Hot short of harness (a con- tact with 5 V circuit or 24 V circuit) aPrepare with starting switch OFF, then start troubleshooting with starting switch ON. Between ground and wiring harness between CE02 (female) (9) – DCL (female) (B) Voltage Max.

1 V 4 Harness short (Harness internal short) aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF. Wiring harness between CE02 (female) (9) – DCL (female) (B) and wiring harness between CE02 (female) (22) – DCL (female) (A) Resis- tance Min. 100 kz 5 Defective wiring harness connector The connections among decelerator pedal – body harness – engine controller are suspected to be defective. Visually check it. • Connector is loose, lock is broken, seal is broken • Pin is corroded, bent, broken, pushed in, expanded.

• Moisture in connector, entry of dirt or sand, etc., and insufficient insulation 6 Defective engine controller aPrepare with starting switch OFF, then start troubleshooting with starting switch ON. CE02 Voltage Between (22) – (23) Power source 4.75 – 5.25 V