Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FAILURE CODE [CA145] COOLANT TEMPERATURE SENSOR TOO LOW: EXCESSIVELY LOW VOLTAGE DETECTED

SEN00589-00 40 Troubleshooting Failure code [CA145] Coolant temperature sensor too low: Excessively low voltage detected 1 48 D65EX, PX, WX-15E0 Action code Failure code Failure symptom Coolant temperature sensor too low: Excessively low voltage detected (Engine controller system) E01 CA145 Failure content • Excessively low voltage is detected at signal circuit of engine coolant temperature sensor. Controller's action • Operates with a fixed engine coolant temperature. Symptoms that appears on machine • Exhaust gas color becomes white. • Overheat prevention function does not work. General information • The signal voltage of engine coolant sensor can be checked in monitoring mode. (Code:

04105 Engine coolant sensor voltage) • Duplication of failure code: turn ON the starting switch. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective engine coolant temperature sensor aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF. C5 (male) Resistance Between (A) – (B) 0.18 – 160 kz Between (B) – chassis ground Min. 100 kz 2 Defective harness grounding (Contact with ground circuit) aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF. Between ground and wiring harness between CE01 (female) (15) – C5 (female) (B) Resis- tance Min.

100 kz 3 Harness short (Harness internal short) aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF. Between CE01 (female) (15) – CE01 (female) all pins (With all connectors in the harness disconnected) Resis- tance Min. 100 kz 4 Defective wiring harness connector The connections among engine coolant temperature sensor – engine harness – engine controller are suspected to be defective. Visually check it. • Connector is loose, lock is broken, seal is broken • Pin is corroded, bent, broken, pushed in, expanded.

• Moisture in connector, entry of dirt or sand, etc., and insufficient insulation 5 Defect in other locations than engine controller aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF. CE01 (female) Resistance Between (15) – (38) 0.18 – 160 kz Between (15) – chassis ground Min. 100 kz 6 Defective engine controller Engine controller is possibly defective if no problem is found in causes 1 – 5. (Internal failure which cannot be diagnosed)