Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FAILURE CODE [CA153] CHARGE TEMPERATURE SENSOR TOO HIGH: EXCESSIVELY HIGH VOLTAGE DETECTED

SEN00589-00 40 Troubleshooting Failure code [CA153] Charge temperature sensor too high: Excessively high voltage detected 1 50 D65EX, PX, WX-15E0 Action code Failure code Failure symptom Charge temperature sensor too high: Excessively high voltage detected (Engine controller system) E01 CA153 Failure content • Excessively high voltage is detected at temperature signal circuit of boost pressure and temperature sensor. Controller's action • Operates with a fixed charge temperature. Symptoms that appears on machine • Exhaust gas color becomes white. • Engine protection function by boost temperature does not work.

General information • The signal voltage of boost pressure and temperature sensor on boost temperature side can be checked in monitoring function. (Code: 18501 Boost temperature sensor voltage) • Duplication of failure code: turn ON the starting switch. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective boost pressure and temperature sensor [temperature signal circuit] aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF.

C4 (male) Resistance Between (3) – (4) 0.18 – 160 kz 2 Disconnection in wiring har- ness (Disconnection or poor con- nector contact) aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF. Wiring harness between CE01 (female) (23) – C4 (female) (3) Resis- tance Max. 10 z Wiring harness among CE01 (female) (47) – S11 – C4 (female) (4) Resis- tance Max. 10 z 3 Harness short (Harness internal short) aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF. Between CE01 (female) (23) – CE01 (female) all pins (With all connectors in the harness disconnected) Resis- tance Min.

100 kz 4 Defective wiring harness connector The connections among boost pressure and temperature sensor – engine harness – engine controller are suspected to be defective. Visually check it. • Connector is loose, lock is broken, seal is broken • Pin is corroded, bent, broken, pushed in, expanded. • Moisture in connector, entry of dirt or sand, etc., and insufficient insulation 5 Defect in other locations than engine controller aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF. CE01 (female) Resistance Between (23) – (47) 0.18 – 160 kz 6 Defective engine controller Engine controller is possibly defective if no problem is found in causes 1 – 5.

(Internal failure which cannot be diagnosed)