SEN00589-00 40 Troubleshooting Failure code [CA154] Charge temperature sensor too low: Excessively low voltage detected 1 52 D65EX, PX, WX-15E0 Action code Failure code Failure symptom Charge temperature sensor too low: Excessively low voltage detected (Engine controller system) E01 CA154 Failure content • Excessively low voltage is detected at temperature signal circuit of boost pressure and temperature sensor. Controller's action • Operates with a fixed charge temperature. Symptoms that appears on machine • Exhaust gas color becomes white. • Engine protection function by boost temperature does not work.
General information • The signal voltage of boost pressure and temperature sensor on boost temperature side can be checked in monitoring function. (Code: 18501 Boost temperature sensor voltage) • Duplication of failure code: turn ON the starting switch. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective boost pressure and temperature sensor [temperature signal circuit] aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF. C4 (male) Resistance Between (3) – (4) 0.18 – 160 kz Between (3) – chassis ground Min.
100 kz 2 Defective harness grounding (Contact with ground circuit) aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF. Between ground and wiring harness between CE01 (female) (23) – C4 (female) (3) Resis- tance Min. 100 kz 3 Harness short (Harness internal short) aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF. Between CE01 (female) (23) – CE01 (female) all pins (With all connectors in the harness disconnected) Resis- tance Min. 100 kz 4 Defective wiring harness connector The connections among boost pressure and temperature sensor – engine harness – engine controller are suspected to be defective. Visually check it.
• Connector is loose, lock is broken, seal is broken • Pin is corroded, bent, broken, pushed in, expanded. • Moisture in connector, entry of dirt or sand, etc., and insufficient insulation 5 Defect in other locations than engine controller aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF. CE01 (female) Resistance Between (23) – (47) 0.18 – 160 kz Between (23) – chassis ground Min. 100 kz 6 Defective engine controller Engine controller is possibly defective if no problem is found in causes 1 – 5. (Internal failure which cannot be diagnosed)