SEN00589-00 40 Troubleshooting Failure code [CA221] Atmospheric pressure sensor too high: Excessivley high voltage detected 1 58 D65EX, PX, WX-15E0 Action code Failure code Failure symptom Atmospheric pressure sensor too high: Excessively high voltage detected (Engine controller system) E01 CA221 Failure content • Excessively high voltage is detected at signal circuit of atmospheric pressure sensor. Controller's action • Operates with a fixed atmospheric pressure. Symptoms that appears on machine • Startability gets worse. • Engine output is reduced. General information • The signal voltage of the atmospheric pressure sensor can be checked in monitoring mode. (Code:
37401 Atmospheric pressure sensor voltage) • Duplication of failure code: turn ON the starting switch. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective sensor power source 1 system If failure code [CA386] is displayed at the same time, carry out trou- bleshooting for that first. 2 Defective atmospheric pres- sure sensor aPrepare with starting switch OFF, then start troubleshooting with starting switch ON.
C29 Voltage Between (1) – (2) Power source 4.75 – 5.25 V Since voltage is measured with the harness connected, further diag- nose the harness and the controller if the voltage is not normal, and then make judgment after it is determined that there is no other defective cause. 3 Hot short of harness (a con- tact with 5 V circuit or 24 V circuit) aPrepare with starting switch OFF, then start troubleshooting with starting switch ON. Between ground and wiring harness between CE01 (female) (3) – C29 (female) (3) Voltage Max. 1 V 4 Harness short (Harness internal short) aPrepare with starting switch OFF, then start troubleshooting with starting switch OFF.
Wiring harness between CE01 (female) (3) – C29 (female) (3) and wiring harness between CE01 (female) (33) – C29 (female) (1) Resis- tance Min. 100 kz 5 Defective wiring harness connector The connections among atmospheric pressure sensor – engine har- ness – engine controller are suspected to be defective. Visually check it. • Connector is loose, lock is broken, seal is broken • Pin is corroded, bent, broken, pushed in, expanded. • Moisture in connector, entry of dirt or sand, etc., and insufficient insulation 6 Defective engine controller aPrepare with starting switch OFF, then start troubleshooting with starting switch ON. CE01 Voltage Between (33) – (38) Power source 4.75 – 5.25 V