Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FAILURE CODE [CA332] INJECTOR NO.4 SYSTEM DISCONNECTION OR SHORT CIRCUIT: DISCONNECTION, SHORT CIRCUIT

SEN00590-00 40 Troubleshooting Failure code [CA332] Injector No. 4 system disconnection or short circuit: disconnection, short circuit 1 14 D65EX, PX, WX-15E0 Action code Failure code Symptom of failure Injector No. 4 system disconnection or short circuit: disconnection, short circuit (Engine controller system) CALL E03 CA332 Failure content • A disconnection or short circuit has been detected in No. 4 injector drive circuit Controller's action • No particular action Symptoms that appears on machine • Poor combustions or hunting occurs. • Engine output is reduced. General information • Duplication of failure code: start the engine.

Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective engine controller If the following failure codes are displayed at the same time, engine controller is internally defective: ([CA323] [CA325] [CA332]) 2 Defective No. 4 injector aPrepare with starting switch OFF and diagnose with starting switch still OFF. C10 (male) Resistance Between (2) – (1) Max. 2 z Between (2) – ground Min. 100 kz 3 Disconnection in wiring har- ness (Disconnection or defective contact of connectors) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between CE01 (female) (56) – C10 (2) – No.

4 injector (1) Resis- tance Max. 2 z Wiring harness between CE01 (female) (58) – C10 (1) – No. 4 injector (2) Resis- tance Max. 2 z 4 Defective harness grounding (Contact with ground circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Between ground and wiring harness between CE01 (female) (56) – C10 (2) – No. 4 injector (1) Resis- tance Min. 100 kz 5 Harness short (Harness internal short) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Between CE01 (female) (56) – CE01 (female) all pins (All connectors in the harness disconnected) Resis- tance Min.

100 kz Between CE01 (female) (58) – CE01 (female) all pins (All connectors in the harness disconnected) Resis- tance Min. 100 kz 6 Defective wiring harness connector Since the problem is possibly at the connections between No. 4 injector – engine harness – engine controller, check for a defective connection. • Connector is loose, lock is broken, seal is broken • Pin is corroded, bent, broken, pushed in, expanded. • Moisture in connector, entry of dirt or sand, etc., and insufficient insulation 7 Defect in other locations than engine controller aPrepare with starting switch OFF and diagnose with starting switch still OFF. CE01 (female) Resistance Between (56) – (58) Max.

2 z Between (56) – ground Min. 100 kz 8 Defective engine controller Engine controller is possibly defective if no problem is found in causes 1 – 7. (Since this is an internal defect, it cannot be diagnosed.)