Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FAILURE CODE [DAQ2KK] [DB32KK] LOAD POWER SOURCE OF STEERING AND TRANSMISSION CONTROLLER: POWER SOURCE VOLTAGE DROP AND INPUT

SEN00591-00 40 Troubleshooting Failure code [DAQ2KK] [DB32KK] Load power source of steering and transmission controller: Power source voltage drop and input 1 22 D65EX, PX, WX-15E0 Action code Failure code Symptom of failure Load power source of steering and transmission controller: Power source voltage drop and input (Steering and transmission controller system) CALL E04 DAQ2KK DB32KK Failure content • Power source voltage of load (relay, solenoid and etc,) on steering and transmission controller is less than 17 V. Controller's action • Flashes warning lamp and turns on alarm buzzer. • Limits operation of engine and transmission.

Symptoms that appears on machine • Relay and solenoid may not drive and therefore, system may not operate normally. • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, it becomes impossible to travel. General information • Both of DAQ2KK and DB32KK are displayed. • Battery charge condition (voltage) can be checked in monitoring mode. (Code 03200: Battery voltage) • Duplication of failure code: turn ON the starting switch. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective fuse FS1-9 If fuse FS1-9 is blown, circuit probably has short circuiting with ground.

2 Disconnection in wiring harness (Disconnection or defective contact of connectors) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between ST3 (female) (2) (12) (22) – FS1-9 Resis- tance Max. 1 z Wiring harness between FS1-3 – battery relay C terminal Resis- tance Max. 1 z Wiring harness between ST3 (female) (21) (31) (32) (33) – ground Resis- tance Max. 1 z 3 Defective harness grounding (Contact with ground circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between ST3 (female) (2) (12) (22) – FS1-9 with ground Resis- tance Min.

1 Mz Wiring harness between FS1-3 – battery relay C terminal with ground Resis- tance Min. 1 Mz 4 Defective steering and transmission controller aPrepare with starting switch OFF and diagnose with starting switch ON. ST3 Voltage Between (2) (12) (22) – (21) (31) (32) (33) 20 – 30 V