SEN00591-00 40 Troubleshooting Failure code [DAQ5KK] [DB35KK] Steering and transmission controller sensor 5 V power source: Power source voltage drop and input 1 24 D65EX, PX, WX-15E0 Action code Failure code Symptom of failure Steering and transmission controller sensor 5 V power source: Power source voltage drop and input (Steering and transmission controller system) CALL E03 DAQ5KK DB35KK Failure content • Voltage of 5 V power source circuit of steering and transmission controller sensor is less than 4.5 V or more than 5.5 V. • Abnormal current flowed in 5 V power source circuit of steering and transmission controller sensor.
Controller's action • Flashes warning lamp and turns on alarm buzzer. • Stops output to 5 V power source circuit if abnormal voltage flows. • Limits operation of engine and transmission. Symptoms that appears on machine • System may not operate normally. • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, travel is limited to F1 and R1. General information • Both of DAQ5KK and DB35KK are displayed. • Duplication of failure code: turn ON the starting switch.
Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective brake potentiometer (Internal short circuit) If right-hand connector is disconnected and service code lights up (to indicate returning to normal), the cause is an internal trouble, aTurn starting switch OFF, disconnect connector, turn the switch ON and carry out troubleshooting.
BRK connector 2 Defective fuel dial potentiom- eter (Internal short circuit) If right-hand connector is disconnected and service code lights up (to indicate returning to normal), the cause is an internal trouble, aTurn starting switch OFF, disconnect connector, turn the switch ON and carry out troubleshooting. DIAL connector 3 Defective forward-reverse potentiometer (Internal short circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. TL2 (male) Resistance Sensor Between (4) – (1) 3.2 kz ± 20% Between (4) – chassis ground Min.
1 Mz 4 Defective steering potenti- ometer (Internal short circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. TL2 (male) Resistance Sensor Between (5) – (8) 3.2 kz ± 20% Between (5) – chassis ground Min. 1 Mz 5 Defective harness grounding (Contact with ground circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between ST1 (female) (22) – TL2 (female) (5), – TL2 (female) (4) – DIAL (female) (A) – BRK (female) (C) with ground. Resis- tance Min. 1 Mz 6 Hot short of wiring harness (Contact with 24 V circuit) aPrepare with starting switch OFF and diagnose with starting switch ON.
Wiring harness between ST1 (female) (22) – TL2 (female) (5), – TL2 (female) (4) – DIAL (female) (A) – BRK (female) (C) with ground. Voltage Max. 1 V