Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FAILURE CODE [DAQ9KQ] [DB39KQ] STEERING AND TRANSMISSION CONTROLLER MODEL SELECTION: INCONSISTENCY IN MODEL SELECT SIGNAL

SEN00591-00 40 Troubleshooting Failure code [DAQ9KQ] [DB39KQ] Steering and transmission controller model selection: Inconsistency in model select signal 1 28 D65EX, PX, WX-15E0 Action code Failure code Symptom of failure Steering and transmission controller model selection: Inconsistency in model select signal (Steering and transmission controller system) CALL E04 DAQ9KQ DB39KQ Failure content • Internal specification setting of steering and transmission controller is inconsistent with specification setting signal. (Steering and transmission controller cannot be recognized normally.) Controller's action • Flashes warning lamp and turns on alarm buzzer.

• Stops all outputs to steering and transmission controller. • Limits operation of engine, transmission and brake. Symptoms that appears on machine • Machine does not operate at all. • Once machine is stopped, engine speed is limited to medium (half). • Once machine is stopped, it becomes impossible to travel. General information • Both of DAQ9KQ and DB39KQ are displayed. • Duplication of failure code: turn ON the starting switch.

Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective steering and trans- mission controller adjustment It is normal if failure code lights on (to indicate returning to normal) after carrying out adjustment mode. • Adjustment code 0002: Steering and transmission controller specification set 2 Disconnection in wiring harness (Disconnection, defective contact of connectors) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harnesses between ST3 (female) (30) – GND01 Resis- tance Max.

1 z 3 Defective harness grounding (Contact with ground circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Between ST3 (female) (40) – PL2 (18) and ground Resis- tance Min. 1 Mz 4 Defective steering and transmission controller aPrepare with starting switch OFF and diagnose with starting switch ON. ST3 Voltage Between (30) – chassis ground Max. 1 V Between (40) – chassis ground 5 – 11 V