Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FAILURE CODE [DD13KB] SHIFT DOWN SWITCH: SHORT CIRCUIT

SEN00591-00 40 Troubleshooting Failure code [DD13KB] Shift down switch: Short circuit 1 40 D65EX, PX, WX-15E0 Action code Failure code Symptom of failure Shift down switch: Short circuit (Steering and transmission controller system) E02 DD13KB Failure content • Signals of two systems of shift down switch circuit were turned ON (CLOSE) at the same time. Controller's action • Flashes warning lamp and turns on alarm buzzer. • Recognizes that switch is not pressed. Symptoms that appears on machine • Cannot shift down. • The auto shift down function does not work. General information • Of signals of two systems of switch, NO is for operation detection and NC is for error detection.

• Input status (ON / OFF) from shift down switch can be checked in monitoring mode. (Code 40905: Transmission-related controller input signal 1) • Method of reproducing failure code: Turn starting switch ON + Operate shift down switch Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective shift down switch (internal short circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. SFTD (female) Shift down switch OFF (Release) ON (Press) Resistance between (2) – (3) Max. 1 z Min. 1 Mz Resistance between (2) – (1) Min. 1 Mz Max.

1 z 2 Defective harness grounding (Contact with ground circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between ST1 (female) (24) – SFTD (male) (3) with ground Resis- tance Min. 1 Mz Wiring harness between ST1 (female) (18) – SFTD (male) (1) with ground Resis- tance Min. 1 Mz 3 Defective steering and transmission controller aPrepare with starting switch OFF and diagnose with starting switch ON. ST1 Shift down switch OFF (Release) ON (Press) Voltage between ST1 (24) – ST1 (4) Max. 1 V 5 – 11 V Voltage between ST1 (18) – ST1 (4) 5 – 11 V Max. 1 V