SEN00591-00 40 Troubleshooting Failure code [DD14KA] [DDQ2KA] Parking brake lever switch: Disconnection 1 42 D65EX, PX, WX-15E0 Action code Failure code Symptom of failure Parking brake lever switch: Disconnection (Steering and transmission controller system) CALL E03 DD14KA DDQ2KA Failure content • Signals of two systems of parking brake lever switch circuit were turned OFF (OPEN) at the same time. Controller's action • Flashes warning lamp and turns on alarm buzzer. • Recognizes that parking brake lever is in free position. • Limits operation of engine and transmission. Symptoms that appears on machine • Once machine is stopped, engine speed is limited to medium (half).
• Once machine is stopped, travel is limited to F1 and R1. • Engine cannot be started. General information • Both of DD14KA and DDQ2KA are displayed. • Of signals of two systems of switch, NO is for operation detection and NC is for error detection. • Input status (ON / OFF) from parking brake switch can be checked in monitoring mode. (Code 40910: Steering-related controller input signal 1) • Method of reproducing failure code:
Turn starting switch ON + Shift parking brake lever Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Parking brake lever switch (internal disconnection) aPrepare with starting switch OFF and diagnose with starting switch still OFF. NSW (male) Parking lever Free position Lock position Resistance between ground (A) – (B) Max. 1 z Min. 1 Mz Resistance between ground (A) – (C) Min. 1 Mz Max. 1 z 2 Disconnection in wiring harness (Disconnection or defective contact of connectors) aPrepare with starting switch OFF and diagnose with starting switch still OFF.
Wiring harness between ST2 (female) (15) – NSW (female) (C) Resis- tance Max. 1 z Wiring harness between ST2 (female) (5) – NSW (female) (B) Resis- tance Max. 1 z Wiring harness between ST1 (female) (4) – NSW (female) (A) Resis- tance Max. 1 z 3 Hot short circuiting in wiring harness (Contact with 24 V circuit) aPrepare with starting switch OFF and diagnose with starting switch ON. Wiring harness between ST2 (female) (15) – NSW (female) (C) with ground. Voltage Max. 1 V Wiring harness between ST2 (female) (5) – NSW (female) (B) with ground. Voltage Max. 1 V 4 Defective steering and transmission controller aPrepare with starting switch OFF and diagnose with starting switch ON.
ST2 Parking lever Free position Lock position Voltage between (5) – ground Max. 1 V 5 – 11 V Voltage between (15) – ground 5 – 11 V Max. 1 V