SEN00591-00 40 Troubleshooting Failure code [DK40KA] Brake potentiometer: Disconnection 1 Circuit diagram related to brake potentiometer 70 D65EX, PX, WX-15E0 Action code Failure code Symptom Br of failure (S ake potentiometer: Disconnection teering and transmission controller system) E01 DK40KA Failure conte nt • Signal voltage of brake potentiometer circuit is less than 0.5 V. Controller's action • Nothing particular. Symptoms th appears on machin at • Automatic shift-down does not function properly • Gear shift shock of transmission increases. e General information • Input status (voltage) from brake potentiometer can be checked in monitoring mode. (Code 50400:
Brake potentiometer voltage) • Method of reproducing failure code: Turn starting switch ON + (Operate brake pedal) Possible causes and t standard valu when norm Cause Defective sensor power Ch 1 source system an a • Defective brake potenti- ometer. (Internal disconnection 2 and short circuit) • Defective installation of potentiometer.
a he es Disconnection in wiring harness al W 3 (Disconnection or defective BR contact of connectors) W BR a Defective harness grounding 4 (Contact with ground circuit) W BR a Defective steering and 5 transmission controller Standard value when normal and remarks for troubleshooting eck displays of failure codes [DAQ5KK] [DB35KK] and if there is y display, carry out that troubleshooting first. Prepare with starting switch OFF and diagnose with starting switch still OFF.
BRK (male) Resistance Between (A) – (C) 4.0 – 6.0 kz Between (A) – (B) 1.5 – 4.5 kz (free – full stroke) Between (B) – (C) 4.5 – 1.5 kz (free – full stroke) Prepare with starting switch OFF and diagnose with starting switch still OFF. iring harness between ST1 (female) (22) – K (female) (C) Resis- tance Max. 1 z iring harness between ST1 (female) (3) – K (female) (B) Resis- tance Max. 1 z Prepare with starting switch OFF and diagnose with starting switch still OFF. iring harness between ST1 (female) (3) – K (female) (B) with ground Resis- tance Min. 1 Mz Prepare with starting switch OFF and diagnose with starting switch ON. ST1 Voltage Between (3) – (21) 1.5 – 4.5 V