Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — FAILURE CODE [DK56KB] FORWARD-REVERSE POTENTIOMETER (1): DISCONNECTION

SEN00591-00 40 Troubleshooting Failure code [DK56KB] Forward-reverse potentiometer (1): Disconnection 1 78 D65EX, PX, WX-15E0 Action code Failure code Symptom of failure Forward-reverse potentiometer (1): Disconnection (Steering and transmission controller system) CALL E03 DK56KB Failure content • Signal voltage of forward-reverse potentiometer (1) system is less than 0.5 V. Controller's action • Flashes warning lamp and turns on alarm buzzer. • Continues to keep it under control with signal of forward-reverse potentiometer (2) system. • Limits operation of engine and transmission. Symptoms that appears on machine • Once machine is stopped, engine speed is limited to medium (half).

• Once machine is stopped, travel is limited to F1 and R1. General information • Input status (voltage) from forward-reverse potentiometer (1) can be checked in monitoring mode. (Code 50200: Forward-reverse potentiometer (1) voltage) • Method of reproducing failure code: Turn starting switch ON +(Shift PCCS lever (forward-reverse)) Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective sensor 5 V power source system Check displays of failure codes [DAQ5KK] [DB35KK] and if there is any display, carry out that troubleshooting first.

2 Defective forward-reverse potentiometer (1) (Internal dis- connection and short-circuit- ing) aPrepare with starting switch OFF and diagnose with starting switch still OFF. TL2 (male) Resistance Between (4) – (1) 3.2 kz ± 20% Between (3) – (4) 5.5 – 1.5 kz (forward – reverse) Between (3) – (1) 1.5 – 5.5 kz (forward – reverse) 3 Disconnection in wiring harness (Disconnection or defective contact of connectors) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between ST1 (female) (22) – TL2 (female) (4) Resis- tance Max. 1 z Wiring harness between ST1 (female) (13) – TL2 (female) (3) Resis- tance Max.

1 z 4 Defective harness grounding (Contact with ground circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between ST1 (female) (13) – TL2 (female) (3) with ground Resis- tance Min. 1 Mz 5 Defective steering and transmission controller aPrepare with starting switch OFF and diagnose with starting switch ON. ST1 Voltage Between (13) – (21) 0.5 – 4.5 V