SEN00592-00 40 Troubleshooting Failure code [DWN1KY] HSS EPC solenoid right: Short circuit to power source line 1 Circuit diagram related to HSS EPC solenoid right 16 D65EX, PX, WX-15E0 Action code Failure code Symptom of failure HSS EPC solenoid right: Short circuit to power source line (Steering and transmission controller system) CALL E04 DWN1KY Failure content • Current flows constantly to HSS EPC solenoid right circuit. Controller's action • Flashes warning lamp and turns on alarm buzzer. • Stops outputting to HSS EPC solenoid right circuit. • Limits operation of engine and transmission. Symptoms that appears on machine • Continues to turn to the right.
• Once machine is stopped, engine speed is limited to medium (half). • Can not travel once machine is stopped. General information • Output state (current) to HSS EPS solenoid right can be checked in monitoring mode. (Code 50603: Right HSS solenoid output current value) • Duplication of failure code: Turn starting switch ON and operate PCCS lever (for steering to right). Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective HSS EPC solenoid right (Internal disconnection and short circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF.
HSB (male) Resistance Between (1) – (2) 5 – 15 z 2 Hot short of wiring harness (a contact with 24 V circuit) aPrepare with starting switch OFF and diagnose with starting switch ON. Between ground and wiring harness between ST3 (female) (35) – HSB (female) (1) Voltag e Max. 1 V 3 Defective steering and transmission controller aPrepare with starting switch OFF and diagnose with starting switch ON. ST3 PCCS lever Voltage Between (35) – (3) Right 5 – 15 V N Max. 1 V