SEN00281-01 10 Structure, function and maintenance standard 1. Hydraulic motor unit Function q This hydraulic motor is called a swash plate- type axial piston motor. It converts the energy of the pressurized oil sent from the hydraulic pump into rotary motion. Principle of operation q The oil sent from the hydraulic pump flows through valve plate (7) into cylinder block (5). This oil can flow on only one side of the (Y-Y) line connecting the top dead center and bottom dead center of the stroke of piston (4). q The oil sent to one side of cylinder block (5) presses piston (4) [2 or 3 pieces], and gener- ates force (F1)[F1 = P x x D 2 /4]. q This force is applied to thrust plate (2).
Since thrust plate (2) is fixed to the angle of ( α °) to output shaft (1), the force is divided into com- ponents (F2) and (F3). q The radial component (F3) generates torque [T = F3 x ri] against the (Y – Y) line connecting the top dead center and bottom dead center. q The result of this torque [T = Σ (F3 x ri)] rotates cylinder block (5) through the piston. q Since this cylinder block (5) is splined to the output shaft, the output shaft revolves to trans- mit the torque. 14 D65EX, PX, WX-15E0