SEN00593-00 40 Troubleshooting E-10 Hydraulic oil temperature gauge does not indicate properly. 1 28 D65EX, PX, WX-15E0 Symptom of failure (1)Though the hydraulic oil temperature rises normally, but the gauge indication does not rise from white range (a). (2)Although the hydraulic oil temperature is stabilized normally, but gauge indication rises to red range (c). General information • Signals of the hydraulic oil temperature sensor are inputted to the steering and transmission control- ler and the information is transmitted to monitor panel through communication system.
• When any abnormality occurred in the hydraulic oil temperature sensor system, the failure code [DGS1KX] may be displayed. • The input state (temperature) from the hydraulic oil temperature sensor can be checked at monitor- ing mode. (Code: 04401 Hydraulic oil temperature) Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective hydraulic oil tem- perature sensor (Internal disconnection and short circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. SDS (male) Resistance Between (1) – (2) 3.5 – 90 kz Between (1) – chassis ground Min.
1 Mz 2 Disconnection in wiring harness (Disconnection or defective contact of connectors) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between ST1 (female) (9) – SDS (female) (1) Resis- tance Max. 1 z Wiring harness between ST1 (female) (21) – SDS (female) (2) Resis- tance Max. 1 z 3 Defective grounding of wiring harness (a contact with GND circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Between ground and wiring harness between ST1 (female) (9) – SDS (female) (1) Resis- tance Min.
1 Mz 4 Hot short of wiring harness (a contact with 24 V circuit) aPrepare with starting switch OFF and diagnose with starting switch ON. Between ground and wiring harness between ST1 (female) (9) – SDS (female) (1) Voltage Max. 1 V Between ground and wiring harness between ST1 (female) (21) – SDS (female) (2) Voltage Max. 1 V 5 Defective steering and transmission controller aPrepare with starting switch OFF and diagnose with starting switch still OFF. ST1 (female) Resistance Between (9) – (21) 3.5 – 90 kz Between (9) – ground Min. 1 Mz 6 Defective monitor panel Since this is an internal defect, it cannot be diagnosed.