SEN00593-00 40 Troubleshooting E-16 Auto shift down is not possible or is not released. 1 34 D65EX, PX, WX-15E0 Symptom of failure • Auto shift down is not possible or is not released. General information Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective auto shift down switch (Internal disconnection or short circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. ASD (male) Auto shift down switch Resistance Between (2) – (3) OFF(0) Min. 1 Mz ON(1) Max.
1 z 2 Disconnection in wiring harness (Disconnection or defective contact of connectors) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between ST2 (female) (37) – ASD (female) (2) Resis- tance Max. 1 z Wiring harness between ASD (female) (3) – ground Resis- tance Max. 1 z 3 Defective grounding of wiring harness (a contact with GND circuit) aPrepare with starting switch OFF and diagnose with starting switch ON. Between ground and wiring harness between ST2 (female) (37) – ASD (female) (2) Voltage Max. 1 V 4 Defective steering and trans- mission controller aPrepare with starting switch OFF and diagnose with starting switch ON.
Between ST2 (37) – ST3 (21), (31), (32) and (33) Auto shift down switch Voltage OFF(0) 5 – 11 V ON(1) Max. 1 V 5 Limitation of function by controller When Causes 1 to 4 are not applicable, the steering and transmis- sion controller may be restricting the function because of other causes.