SEN00593-00 40 Troubleshooting E-19 The fan cleaning does not operate or cannot be reset. 1 40 D65EX, PX, WX-15E0 Symptom of failure The fan cleaning does not operate or cannot be reset. General information aThis troubleshooting describes the procedures to be followed when the fan rotation selector switch is abnormal. • In case fan operation confirmation lamp correctly lights up and go off by switch operation, but fan does not reverse or reverses, carry out troubleshooting for failure codes [DW7BKA], [DW7BKB].
Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective fan rotation selec- tor switch (Internal disconnection and short circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. FAM (male) Fan rotation selector switch Resistance Between (1) – (2) OFF(0) Min. 1 Mz CLN Max. 1 z 2 Disconnection in wiring harness (Disconnection or defective contact of connectors) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Wiring harness between ST2 (female) (7) – FAM (female) (2) Resis- tance Max. 1 z Wiring harness between FAM (female) (1) – GND04 Resis- tance Max.
1 z 3 Defective harness grounding (Contact with ground circuit) aPrepare with starting switch OFF and diagnose with starting switch still OFF. Between ground and wiring harness between ST2 (female) (7) – FAM (female) (2) Resis- tance Max. 1 Mz 4 Defective steering transmis- sion controller aPrepare with starting switch OFF and diagnose with starting switch ON. Steering and trans- mission controller Fan rotation selector switch Voltage Between ST2 (7) and ST3 (21), (31), (32), (33) OFF(0) 5 – 11 V CLN Max. 1 V