SEN00594-00 40 Troubleshooting H-18 Excessive hydraulic drift of ripper lift 1 16 D65EX, PX, WX-15E0 Symptom of failure • Excessive hydraulic drift of ripper lift. General information • Check for modifications to the ripper. • Check for oil leaks in the hydraulic circuit of the work equipment before troubleshooting. Possible causes and the standard values when normal Cause Standard value when normal and remarks for troubleshooting 1 Defective seal of ripper lift control valve (spool) aPrepare with the engine started, and then stop the engine for troubleshooting. 1. Pull out the shank pin and raise the ripper to the maximum. 2. Disconnect the hose on the cylinder head side and block it.
Ripper lift Hydraulic drift Block ripper lift circuit 50 mm/15 min 2 Defective seal of ripper lift cylinder The seal of the ripper lift cylinder is assumed to be defective; visu- ally check it.