50 Disassembly and assembly SEN00946-00 23. Remove mounting bolts (23) and lift off radiator assembly (24). [*4] Installation q Carry out installation in the reverse order to removal. 4 Radiator assembly: 25 kg 24. Remove radiator hose (25). q Turbocharger side [*1] 3 Clamp: 7 ± 1.1 Nm {0.71 ± 0.11 kgm} q Air aftercooler side 3 Air hose clamp: 10.5 ± 0.5 Nm {1.07 ± 0.05 kgm} Reference If the MIKALOR clamp was removed, install new one carefully according to the following procedure. a Use a new MIKALOR clamp. a Set the hose to the original (marked) position. (Insertion depth of air hose:
60 mm) a Set the bridge (BR) so that its clamp bolt will be at the bottom and it will be lapped over band (BD) by at least min. 5 mm. 2 Threads of clamp bolt: Lubricating oil THREEBOND, PAND18B a Do not use an impact wrench. q When reusing the hose a Set the clamp to its original position. 3 MIKALOR clamp: Min. 6 Nm (1.6 kgm} q When using a new hose a Tighten until band gap (BDG) is 17 – 20 mm . [*2], [*3] 3 Radiator hose clamp: 8.8 ± 0.5 Nm {0.9 ± 0.05 kgm} D65EX, PX, WX-15E0 11