SEN00947-00 50 Disassembly and assembly Connection [*7] a Using push tool [4], install oil seal (22) to retainer (15). q Carry out connection in the reverse order to disconnection. 2 Periphery of press fitting surface of oil seal and inside wall of hole of retainer: Gasket sealant (LG-5) a Wipe off the projected gasket sealant. 2 Lip of oil seal: Grease (G2-LI) [*1] 3 Mounting bolt of bracket (3): 98 – 123 Nm {10.0 – 12.5 kgm} [*2] a If the cable nut was loosened, adjust it. For details, see Testing and adjusting, “Adjusting parking brake lever”. [*3] a Apply gasket sealant (LG-6) to the threads of only 1 mounting bolt (21) of tube (20). [*8] 3 Mounting bolt:
58.8 – 73.5 Nm {6.0 – 7.5 kgm} q Refilling with oil 5 Power train case: 48 l (TO30) [*4] 3 Mounting bolt: 98 – 123 Nm {10.0 – 12.5 kgm} [*5] 3 Mounting bolt: 245 – 309 Nm {25 – 31.5 kgm} [*6] 2 O-ring between coupling and shaft: Grease (G2-LI) 2 Mounting bolt: Liquefied adhesive (LT-2) 3 Mounting bolt: 245.1 – 309.0 Nm {25.0 – 31.5 kgm} 8 D65EX, PX, WX-15E0