SEN00947-00 50 Disassembly and assembly 2) Hold the inner race side of bearing (23) with push tool [4] and install gear (22) to the bearing. 3) Install spacer (17). 4) Install outer race (18) to gear (15). 5) Install gear (15). 6) Install bearing (16). a Press fit inner race side. 3) Install snap rings (20) and (21). 3. Idler gear 1) Fit the O-ring to shaft (14) and install them to the case. 7) Fit plate (13) and tighten bolts. 2 O-ring: Grease (G2-LI) 2) Install bearing (16). 2 Mounting bolt: Liquefied adhesive (LT-2) 3 Mounting bolt: 156.9 – 196.1 Nm {16.0 – 20.0 kgm} 12 D65EX, PX, WX-15E0