50 Disassembly and assembly SEN00947-00 Assembly a Clean all parts, and check for dirt or damage. a Check that the snap ring is fitted securely in the groove. 3) Install seal ring (18) and flange (19) to sta- tor shaft (17). a Coat the seal ring with grease (G2-LI) and align the end gaps. a Take care not to open the abutment joint of the seal ring too much. 1. Pump assembly 1) Press fit bearing (25) to cage (24), and install snap ring (23). 4) Using push tool [4], install pump assembly (16) to stator shaft (17). a Push the inner race of the bearing to press fit. a After press fitting the bearing, apply 6 cc of EO10-CD or EO30-CD in drops, then rotate 10 times.
2) Install cage assembly (21) to pump (22). 2 Mounting bolt (20): Liquefied adhesive (LT-2) 3 Mounting bolt: 58.9 – 73.6 Nm {6 – 7.5 kgm} 2. Stator 1) Install stator (15). 2) Install snap ring (14). D65EX, PX, WX-15E0 17