50 Disassembly and assembly SEN00947-00 Assembly 2. Cage (For fixing No. 5 carrier) 1) Install bearing (108) to cage (107) with the push tool. 2) Install seal ring (109) to cage (107). q Precautions for assembly a Clean the all parts and check them for dirt or damage before installing. a Coat the sliding surfaces of each part with engine oil before installing. a Install seal ring (a) for the piston and pis- ton housing with power receiving side (b) to housing (c) as shown in the figure. a Apply grease (G2-LI) to each seal ring and install it evenly. a Before cooling the bearing in dry ice, etc.
for expansion fit, drop about 6 cc of engine oil (EO10-CD or EO30-CD) onto it and revolve it 10 turns. 3) Install cage (107) to housing (112) with push tool [12]. a Press fit the inner race side of bearing (108). 4) Install snap ring (106). 1. Output shaft bearing 1) Using push tool [11], install bearing (111) to housing (112). 2) Install snap ring (110). 3. No. 5 ring gear Install No. 5 ring gear (105). D65EX, PX, WX-15E0 27