SEN00948-00 50 Disassembly and assembly iii) Install holder (13) and tighten bolt (12). ii) Install gear assembly (6). iii) Install cage (7) and ball (8), matching them to the hole for ball (8). iv) Install snap ring (12). 3 Mounting bolt: 98 – 123 Nm {10 – 12.5 kgm} iv) Install tube (11). 10. Installation of cover assembly 1) Install 2 sleeves (25) and 5 sleeves (24) to the HSS case. 4) Input gear assembly i) Install bearings (10) to gear (9). 2) Using eyebolts [1], install cover assembly (5). 2 Mating face of cover: Gasket sealant (LG-6) a Apply gasket sealant to both mating faces of the case and cover. a Apply gasket sealant to each mating face without breakage. 18 D65EX, PX, WX-15E0