SEN00948-00 50 Disassembly and assembly Removal and installation of final drive assembly 1 5. Remove cover (2). [*2] 6. Use bolt [3] to pull drive shaft (3) out to a posi- tion where spline portion comes out. a If the shaft will not come out, move the sprocket (use a jack to push up the shoe grouser from the ground), and adjust to a position where the shaft can be removed. Then pull the shaft out. Special tools 7. Leave 2 or 3 of 11 inside mounting bolts (4) and 9 outside mounting bolts in position at top, and remove remaining mounting bolts. [*3] Removal 1. Remove track shoe assembly. For details, "Removal of track shoe assembly." 2.
Using jack, jack up chassis, then set stands [1] and [2] under front frame and steering case. k Set the stands in position securely. 8. Remove 2 cover mounting bolts from final drive case, then set tool J1 and lever block in posi- tion, and sling final drive assembly (5). [*4] 9. Remove the remaining bolts and move the final drive assembly outward to remove it from the case. a While operating the lever block and keep- ing the clearance between the final drive case assembly and the case even, pry off the final drive assembly with a bar, etc. 3. Drain oil from final drive case. 6 Final drive case: D65EX: 24 l 4 Final drive assembly: 850 kg D65PX: 27 l D65WX: 27 l 10. Remove sprocket (6). 4.
Remove bracket (1). [*1] 20 D65EX, PX, WX-15E0 Symbol Part number Necessity Part name Q’ty N/R Sketch J1 790-337-1032 Lifting tool t 1 791-427-1090 Plate t 1 01010-51635 Bolt t 2