Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — REMOVAL AND INSTALLATION OF IDLER ASSEMBLY

SEN00949-00 50 Disassembly and assembly Removal and installation of idler assembly 1 4. Raise idler assembly and pull out, then remove mounting bolts of support (5) and yoke (6). Removal 5. Lift off idler assembly (7). 4 Idler: 200 kg 1. Remove track shoe assembly. For details, see "Expansion and installation of track shoe assembly." 2. Remove lock plate (1), then remove lubricator (2). k The inside of the recoil spring cylinder is under negative pressure, so if the lubricator is not removed, the yoke will be pulled back into the cylinder when the yoke and idler support are discon- nected. k To prevent danger, never stand in front of or behind the recoil spring assem- bly.

Installation q Carry out installation in the reverse order to removal. [*1] a Standard shim thickness: 4 mm a Adjust the shim thickness so that clearance (a) between the track frame and guide plate (3) is 0.5 – 1.0 mm. 2 Thread of guide plate mounting bolt: Liquefied adhesive (LT-2) 3. Remove left and right guide plates (3). [*1] a Remove shims (4), check the number and thickness, and keep in a safe place. 4 D65EX, PX, WX-15E0