102 GETTING TO KNOW YOUR INSTRUMENT PANEL LaneSense Indicator Light — If Equipped Check for an inoperative outside light bulb if either indicator flashes at a rapid rate. Set Speed Display The LaneSense indicator light illuminates solid green when both lane markings have been detected and the system is “armed” and ready to provide visual and torque warnings if an unintentional lane departure occurs Ъ page154. Front Fog Indicator Light — If Equipped If equipped with fog lamps, the fog lamp on the side of the activated turn signal will also illuminate to provide additional light when turning.
Cruise Control Set Indicator Light — If Equipped The Set Speed Display indicator light indicates the set speed for the Speed Control and ACC settings. LaneSense Indicator Light — If Equipped When the LaneSense system is ON, but not armed, the LaneSense indicator light illuminates solid white. This occurs when only left, right, or neither lane line has been detected. If a single lane line is detected, the system is ready to provide only visual warnings if an unintentional lane departure occurs on the detected lane line Ъ page154. B LUE I NDICATOR L IGHTS This indicator light will illuminate when the front fog lights are on.
This indicator light will illuminate when the cruise control is set to the desired speed Ъ page139. W HITE I NDICATOR L IGHTS Turn Signal Indicator Lights When the left or right turn signal is activated, the turn signal indicator will flash independently and the corresponding exterior turn signal lamps will flash. Turn signals can be activated when the multifunction lever is moved down (left) or up (right). Adaptive Cruise Control (ACC) Ready Light — If Equipped This light will illuminate when the vehicle equipped with ACC has been turned on but not set Ъ page141.
Cruise Control Ready Indicator High Beam Indicator Light This indicator light will illuminate to indicate that the high beam headlights are on. With the low beams activated, push the multifunction lever forward (toward the front of the vehicle) to turn on the high beams. Pull the multifunction lever rearward (toward the rear of the vehicle) to turn off the high beams. If the high beams are off, pull the lever toward you for a temporary high beam on, "flash to pass" scenario. NOTE: A continuous chime will sound if the vehicle is driven more than 1mile (1.6km) with either turn signal on. This indicator light will illuminate when the cruise control is ready, but not set Ъ page139.