106 STARTING AND OPERATING WARNING! WARNING! AutoPark will engage when all of these conditions are met: AutoPark is a supplemental feature. It is not designed to replace the need to shift your vehicle into PARK. It is a back up system and should not be relied upon as the primary method by which the driver shifts the vehicle into PARK. Vehicle is equipped with a rotary shifter and an 8-speed transmission If vehicle speed is above 1.2mph (1.9km/h), the transmission will default to NEUTRAL until the vehicle speed drops below 1.2mph (1.9km/h). A vehicle left in the NEUTRAL position can roll. As an added precaution, always apply the parking brake when exiting the vehicle.
Vehicle is not in PARK Vehicle speed is 1.2mph (1.9km/h) or less Driver’s seat belt is unbuckled Driver’s door is ajar If the vehicle is not in PARK and the driver turns off the engine, the vehicle may AutoPark. Brake pedal is not pressed 4WD Low — If Equipped AutoPark will be disabled when operating the vehicle in 4WD LOW. AutoPark will engage when all of these conditions are met: The message “AutoPark Engaged Shift to P then Shift to Gear” will display in the instrument cluster. The message “AutoPark Disabled” will be displayed in the instrument cluster. Vehicle is equipped with a rotary shifter and an 8-speed transmission NOTE:
In some cases the ParkSense graphic will be displayed in the instrument cluster, causing the “AutoPark Engaged Shift to P then Shift to Gear” to not be seen. In these cases, the shifter must be returned to “P” to select desired gear. If the driver shifts into PARK while moving, the vehicle may AutoPark. Vehicle is not in PARK Additional customer warnings will be given when all of these conditions are met: Vehicle speed is 1.2mph (1.9km/h) or less Ignition is switched from ON/RUN to ACC Vehicle is not in PARK Driver’s door is ajar NOTE: For Keyless Enter ‘n Go™ equipped vehicles, the engine will turn off and the ignition switch will change to ACC position.
After 30minutes the ignition switches to OFF automatically, unless the driver turns the ignition switch OFF. If the vehicle is not in PARK and the driver exits the vehicle with the engine running, the vehicle may AutoPark. Vehicle is in 4WD Low range AutoPark will engage ONLY when vehicle speed is 1.2mph (1.9km/h) or less. The message “AutoPark Not Engaged” will be displayed in the instrument cluster. A warning chime will continue until you shift the vehicle into PARK or the driver’s door is closed. The message “Vehicle Speed is Too High to Shift to P” will be displayed in the instrument cluster if vehicle speed is above 1.2mph (1.9km/h).
ALWAYS DO A VISUAL CHECK that your vehicle is in PARK by looking for the “P” in the instrument cluster display and near the shifter. As an added precaution, always apply the parking brake when exiting the vehicle.