STARTING AND OPERATING 109 A UTOMATIC T RANSMISSION 4. If you wish to stop the cranking of the engine prior to the engine starting, remove your foot from the brake pedal and push the ENGINE START/STOP button again. the ENGINE START/STOP button once will turn the engine off. The ignition will remain in the ACC position. Start the engine with the transmission in the NEUTRAL or PARK position. Apply the brake before shifting to any driving range. Tip Start Feature NOTE: 5. If the vehicle speed is above 5mph (8km/h), the ENGINE START/STOP button must be held for two seconds (or three short pushes in a row) to turn the engine off.
The ignition will remain in the ACC position (NOT the OFF position) if the engine is turned off when the transmission is not in PARK. Do not press the accelerator. Place the ignition switch briefly to the START position and release it. The starter motor will continue to run and will automatically disengage when the engine is running. K EYLESS E NTER N G O GNITION Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal. Under cold weather conditions, the engine may not immediately crank if the "Wait to Start" tell tale is illuminated. This is normal operation.
For vehicles equipped with Keyless Enter ‘n Go™, the vehicle will automatically crank when the "Wait to Start" time has elapsed Ъ page111. NOTE: If the ignition is left in the ACC or ON/RUN (engine not running) position and the transmission is in PARK, the system will automatically time out after 30minutes of inactivity and the ignition return to the OFF position. 4 This feature allows the driver to operate the ignition switch with the push of a button, as long as the Remote Start/Keyless Enter ‘n Go™ key fob is in the passenger compartment. Normal Starting TO TURN OFF THE ENGINE USING ENGINE START/STOP BUTTON 1.
Place the gear selector in PARK, then push and release the ENGINE START/STOP button. ENGINE START/STOP BUTTON FUNCTIONS — WITH DRIVER’S FOOT OFF THE BRAKE PEDAL (IN PARK OR NEUTRAL POSITION) USING THE ENGINE START/STOP BUTTON 1. The transmission must be in PARK or NEUTRAL. 2. The ignition will return to the OFF position. The ENGINE START/STOP button operates similar to an ignition switch. It has three positions: OFF, ACC, and RUN. To change the ignition switch positions without starting the vehicle and use the accessories follow these steps: 2. Press and hold the brake pedal while pushing the ENGINE START/STOP button once. 3.
If the gear selector is not in PARK and the ENGINE START/STOP button is pushed once, the instrument cluster will display a “Vehicle Not In Park” message and the engine will remain running. Never leave a vehicle out of the PARK position, or it could roll. 3. The system takes over and attempts to start the vehicle. If the vehicle fails to start, the starter will disengage automatically after 25 seconds. 1. Start with the ignition in the OFF position. 4. If the gear selector is in NEUTRAL, and the vehicle speed below 5mph (8km/h), pushing 2. Push the ENGINE START/STOP button once to change the ignition to the ACC position.