298 SAFETY Installing A Child Restraint With A Switchable Automatic Locking Retractor (ALR): For Regular Cab Models 8. If the child restraint has a top tether strap and the seating position has a top tether anchorage, connect the tether strap to the anchorage and tighten the tether strap. See Ъ page299 for directions to attach a tether anchor. Place the child seat in the center of the seating position. Move the vehicle seat as far rearward as possible to keep the child as far from the passenger air bag as possible. Child restraint systems are designed to be secured in vehicle seats by lap belts or the lap belt portion of a lap/shoulder belt. 2.
Pull enough of the seat belt webbing from the retractor to pass it through the belt path of the child restraint. Do not twist the belt webbing in the belt path. 9. Test that the child restraint is installed tightly by pulling back and forth on the child seat at the belt path. It should not move more than 1inch (25.4mm) in any direction. WARNING! Improper installation or failure to properly secure a child restraint can lead to failure of the restraint. The child could be badly injured or killed. 3. Slide the latch plate into the buckle until you hear a “click.” Any seat belt system will loosen with time, so check the belt occasionally, and pull it tight if necessary.
Installing A Child Restraint With A Cinching Latch Plate (CINCH) — If Equipped: 4. Pull on the webbing to make the lap portion tight against the child seat. Follow the child restraint manufacturer’s directions exactly when installing an infant or child restraint. 5. To lock the seat belt, pull down on the shoulder part of the belt until you have pulled all the seat belt webbing out of the retractor. Then, allow the webbing to retract back into the retractor. As the webbing retracts, you will hear a clicking sound. This means the seat belt is now in the Automatic Locking mode.
Child restraint systems are designed to be secured in vehicle seats by lap belts or the lap belt portion of a lap/shoulder belt. 1. For Crew Cab Models Place the child seat in the center of the seating position. If the second row seat can be re clined, you may recline the seat and/or raise the head restraint (if adjustable) to get a better fit. If the rear seat can be moved forward and rearward in the vehicle, you may wish to move it to its rear-most position to make room for the child seat. You may also move the front seat forward to allow more room for the child seat. Improper installation or failure to properly secure a child restraint can lead to failure of the restraint.
The child could be badly injured or killed. WARNING! 6. Try to pull the webbing out of the retractor. If it is locked, you should not be able to pull out any webbing. If the retractor is not locked, repeat step 5. 7. Finally, pull up on any excess webbing to tighten the lap portion around the child restraint while you push the child restraint rearward and downward into the vehicle seat. Follow the child restraint manufacturer’s directions exactly when installing an infant or child restraint.