300 SAFETY Regular Cab Trucks: 2. Route the tether strap to provide the most direct path between the anchorage and the child seat. The tether strap should go between the head restraint posts underneath the head restraint. You may need to adjust the head restraint to the upward position to pass the tether strap underneath the head restraint and between its posts. Right Or Left Outboard Seats: In the regular cab truck, the top tether anchorages are located behind the center and right passenger seats. There is a plastic cover over each anchorage. To attach the tether strap of the child restraint: 1.
Raise the head restraint and reach between the rear seat and rear glass to access the tether strap loop. 1. Place the child restraint on the seat and adjust the tether strap so that it will reach over the seat back, under the head restraint and to the tether anchor directly behind the seat. 3. Lift the cover (if so equipped), and attach the hook to the square opening in the sheet metal. Tighten the tether strap according to the child seat manufacturer’s instructions. Never place a rear-facing child restraint in front of an air bag. A deploying Passenger Front Air Bag can cause death or serious injury to a child 12 years or younger, including a child in a rear-facing child restraint.
WARNING! Head Restraint In Raised Position Crew Cab Trucks Regular Cab Tether Anchorages The top tether anchorages in this vehicle are tether strap loops located between the rear glass and the back of the rear seat. There is a tether strap loop located behind each seating position. Follow the steps below to attach the tether strap of the child restraint. 1 — Tether Anchor 2 — Tether Strap Hook 3 — Tether Strap To Child Restraint Tether Strap Loop With Center Head Restraint In Raised Position