FCA 2022 Chassis Cab — Installing Child Restraints Using The Top Tether Anchorage

302 SAFETY 3. Pass the tether strap hook under the head restraint behind the child seat, though the tether strap loop behind the seat and over to the right or left outboard tether strap loop. 5. Tighten the tether straps according to the child seat manufacturer’s instructions, tightening the right and left tether straps before the center tether strap. Tether Strap Through Center Tether Strap Loop And Attached To Outboard Tether Strap Loop Installing Three Child Restraints: Tether Strap Through Center Tether Strap Loop 1. Place a child restraint on each outboard rear seat. Route the tether straps following the directions for right and left seating positions, above.

Outboard And Center Seating Positions Shown 4. Attach the hook to the outboard tether strap loop (see diagram). Tighten the tether strap according to the child seat manufacturer’s instructions. WARNING!­ 2. Attach both hooks to the center tether strap loop, but do not tighten the straps yet. An incorrectly anchored tether strap could lead to increased head motion and possible injury to the child. Use only the anchorage position directly behind the child seat to secure a child restraint top tether strap. 3. Place a child restraint on the center rear seat. Route the tether strap following the directions for the center seating position, above. 4.

Attach the hook to the outboard tether strap loop. If your vehicle is equipped with a split rear seat, make sure the tether strap does not slip into the opening between the seatbacks as you remove slack in the strap.