FCA 2022 Chassis Cab — Jump Starting Procedure

IN CASE OF EMERGENCY 315 NOTE: 1. Apply the parking brake, shift the automatic transmission into PARK and turn the ignition OFF. WARNING!­ NOTE: Do not jump off fuses. Only jump directly off positive post. 2. Connect the opposite end of the positive (+) jumper cable to the positive (+) post of the booster battery. Do not allow vehicles to touch each other as this could establish a ground connection and personal injury could result. 2. Turn off the heater, radio, and all electrical accessories. 3. If using another vehicle to jump start the battery, park the vehicle within the jumper cables reach, apply the parking brake, and make sure the ignition is OFF. J UMP S TARTING P ROCEDURE 3.

Connect the negative (-) end of the jumper cable to the negative (-) post of the booster battery. WARNING!­ Failure to follow this jump starting procedure could result in personal injury or property damage due to battery explosion. 4. Connect the opposite end of the negative (-) jumper cable to a good engine ground. A “ground” is an exposed metallic/unpainted part of the engine, frame or chassis, such as an accessory bracket or large bolt. The ground must be away from the battery and fuel injection system. WARNING!­ Take care to avoid the radiator cooling fan whenever the hood is raised. It can start anytime the ignition switch is ON. You can be injured by moving fan blades.

Failure to follow these procedures could result in damage to the charging system of the booster vehicle or the discharged vehicle. CAUTION!­ Remove any metal jewelry such as rings, watch bands and bracelets that could make an inadvertent electrical contact. You could be seriously injured. 7 NOTE: Make sure at all times that unused ends of jumper cables are not contacting each other or either vehicle while making connections. Connecting The Jumper Cables Batteries contain sulfuric acid that can burn your skin or eyes and generate hydrogen gas which is flammable and explosive. Keep open flames or sparks away from the battery. 1.

Connect the positive (+) end of the jumper cable to the positive (+) post of the discharged vehicle. Jump Starting Label