FCA 2022 Chassis Cab — Accessory Drive Belt Inspection

342 SERVICING AND MAINTENANCE 8. Pull the tension tether outward and reinstall the glove compartment past the travel stops by pushing in on the glove compartment sides. A CCESSORY D RIVE B ELT I NSPECTION WARNING!­ Do not attempt to inspect an accessory drive belt with vehicle running. When working near the radiator cooling fan, disconnect the fan motor lead. The fan is temperature controlled and can start at any time regardless of ignition mode. You could be injured by the moving fan blades. Accessory Belt (Serpentine Belt) You can be badly injured working on or around a motor vehicle. Only do service work for which you have the knowledge and the proper equip­ ment.

If you have any doubt about your ability to perform a service job, take your vehicle to a competent mechanic. Rib chunking (one or more ribs has separated from belt body) Conditions that would require replacement: Glove Compartment 1 — Glove Compartment Travel Stop 2 — Glove Compartment Tension Tether 3 — Glove Compartment Door Rib or belt wear Longitudinal belt cracking (cracks between two ribs) When inspecting accessory drive belts, small cracks that run across ribbed surface of belt from rib to rib, are considered normal. These are not a reason to replace belt. However, cracks running along a rib (not across) are not normal. Any belt with cracks running along a rib must be replaced.

Also have the belt replaced if it has excessive wear, frayed cords or severe glazing. Belt slips NOTE: Ensure the glove compartment door hinges and glove compartment travel stops are fully engaged. 9. Reattach the glove compartment tension tether by inserting the tether clip in the glove compartment and sliding the clip away from the face of the glove compartment door. Groove jumping (belt does not maintain correct position on pulley) Belt broken (identify and correct problem before new belt is installed) Noise (objectionable squeal, squeak, or rumble is heard or felt while drive belt is in operation) Some conditions can be caused by a faulty component such as a belt pulley.

Belt pulleys should be carefully inspected for damage and proper alignment.