FCA 2022 Chassis Cab — Noise Emission Warranty

SERVICING AND MAINTENANCE 357 should be replaced according to the procedures and specifications outlined in the appropriate service manual. Among those acts presumed to constitute tampering are the following: Noise Emission Warranty AIR CLEANER The manufacturer warrants that this vehicle as manufactured by the manufacturer, was designed, built and equipped to conform at the time it left the manufacturer's control with all applicable US EPA Noise Control Regulations. Inspect air cleaner housing for proper assembly and fit. Make certain that the air cleaner is properly positioned and that the cover is tight. Check all hoses leading to the air cleaner for tightness.

The air filter element must also be clean and serviced according to the instructions outlined in the Scheduled Maintenance section of this manual. Tampering With Noise Control System Prohibited Air Cleaner Assembly Removal of the air cleaner. Removal of the air cleaner filter element from the air cleaner housing. This warranty covers this vehicle as designed, built and equipped by the manufacturer, and is not limited to any particular part, component or system of the vehicle manufactured by the manufacturer.

Defects in design, assembly or in any part, component or system of the vehicle as manufactured by the manufacturer, which, at the time it left the manufacturer's control, caused noise emissions to exceed Federal standards, are covered by this warranty for the life of the vehicle. Removal of the air ducting. EXHAUST SYSTEM Removal of, or rendering inoperative exhaust system components including the muffler or tail­ pipe. ENGINE COOLING SYSTEM Federal law prohibits the following acts or the causing thereof:

(1) the removal or rendering inoperative by any person, other than for purposes of maintenance, repair, or replacement, of any device or element of design incorporated into any new vehicle for the purpose of noise control prior to its sale or delivery to the ultimate purchaser or while it is in use, or (2) the use of the vehicle after such device or element of design has been removed or rendered inoperative by any person. Removal of, or rendering inoperative the fan clutch. Removal of the fan shroud. 8