FCA 2022 Chassis Cab — Run Flat Tires — If Equipped

SERVICING AND MAINTENANCE 379 Inflation pressures specified on the placard are always “cold tire inflation pressure”. Cold tire inflation pressure is defined as the tire pressure after the vehicle has not been driven for at least three hours, or driven less than 1­mile (1.6­km) after sitting for a minimum of three hours. The cold tire inflation pressure must not exceed the maximum inflation pressure molded into the tire sidewall. Tire Pressures For High Speed Operation Tire Repair The manufacturer advocates driving at safe speeds and within posted speed limits.

Where speed limits or conditions are such that the vehicle can be driven at high speeds, maintaining correct tire inflation pressure is very important. Increased tire pressure and reduced vehicle loading may be required for high-speed vehicle operation. Refer to an authorized tire dealer or original equipment vehicle dealer for recommended safe operating speeds, loading and cold tire inflation pressures. If your tire becomes damaged, it may be repaired if it meets the following criteria: The tire has not been driven on when flat. The damage is only on the tread section of your tire (sidewall damage is not repairable). The puncture is no greater than a ј of an inch (6­mm).

Check tire pressures more often if subject to a wide range of outdoor temperatures, as tire pressures vary with temperature changes. Consult an authorized tire dealer for tire repairs and additional information. Tire pressures change by approximately 1 psi (7 kPa) per 12°F (7°C) of air temperature change. Keep this in mind when checking tire pressure inside a garage, especially in the Winter. WARNING!­ Damaged Run Flat tires, or Run Flat tires that have experienced a loss of pressure should be replaced immediately with another Run Flat tire of identical size and service description (Load Index and Speed Symbol). Replace the tire pressure sensor as well as it is not designed to be reused.

Run Flat Tires — If Equipped High speed driving with your vehicle under maximum load is dangerous. The added strain on your tires could cause them to fail. You could have a serious collision. Do not drive a vehicle loaded to the maximum capacity at continuous speeds above 75­mph (120­km/h). Example: If garage temperature = 68°F (20°C) and the outside temperature = 32°F (0°C) then the cold tire inflation pressure should be increased by 3 psi (21 kPa), which equals 1 psi (7 kPa) for every 12°F (7°C) for this outside temperature condition. Radial Ply Tires Run Flat tires allow you the capability to drive 50­miles (80­km) at 50­mph (80­km/h) after a rapid loss of inflation pressure.

This rapid loss of inflation is referred to as the Run Flat mode. A Run Flat mode occurs when the tire inflation pressure is of/or below 14 psi (96 kPa). Once a Run Flat tire reaches the Run Flat mode it has limited driving capabilities and needs to be replaced immediately. A Run Flat tire is not repairable. When a Run Flat tire is changed after driving with underinflated tire 8 Tire pressure may increase from 2 to 6 psi (13 to 40 kPa) during operation. DO NOT reduce this normal pressure build up or your tire pressure will be too low. WARNING!­ Combining radial ply tires with other types of tires on your vehicle will cause your vehicle to handle poorly.

The instability could cause a collision. Always use radial ply tires in sets of four. Never combine them with other types of tires.