TECHNICAL SPECIFICATIONS 397 Fuel Quality — Must Comply With ASTM Standards Biodiesel fuel has a natural affinity to water and water accelerates microbial growth. Your Mopar®/ Cummins® filtration system is designed to provide adequate fuel water separation capabilities. Biodiesel Fuel Properties — Low Ambient Temperatures CAUTION! The quality of biodiesel fuel may vary widely. Only fuel produced by a BQ9000 supplier to the following specifications may be blended to meet biodiesel blend (B6–B20) fuel meeting ASTM specification D-7467: Under no circumstances should oil change intervals exceed 12,500miles (20,000km) if operation occurs with greater than 5% biodiesel blends.
Oil change intervals should not exceed six months in either case. Failure to comply with these Oil Change requirements for vehicles operating on biodiesel blends up to B20may result in premature engine wear. Such wear is not covered by the New Vehicle Limited Warranty. Biodiesel fuel may gel or solidify at low ambient temperatures, which may pose problems for both storage and operation. Precautions can be necessary at low ambient temperatures, such as storing the fuel in a heated building or a heated storage tank, or using cold temperature additives.
Fuel In Oil Dilution — Must Adhere To Required Oil Change Interval Petrodiesel fuel meeting ASTM specification D-975 and biodiesel fuel (B100) meeting ASTM specification D-6751. Fuel Oxidation Stability — Must Use Fuel Within Six Months Of Manufacture B20 Biodiesel capable: The engine may suffer severe damage if operated with concentra tions of Biodiesel higher than 20%. Biodiesel fuel has poor oxidation stability which can result in long term storage problems. Fuel produced to approved ASTM standards, if stored properly, provides for protection against fuel oxidation for up to six months.
Fuel Water Separation — Must Use Mopar®/Cummins® Approved Fuel Filter Elements Fuel dilution of lubricating oil has been observed with the use of biodiesel fuel. Fuel in oil must not exceed 5%. To ensure this limit is met your oil change interval must be maintained to the following schedule: Ram 3500/4500/5500 Chassis Cab — You must use Mopar®/Cummins® approved fuel filter elements in both your engine mounted filter and frame mounted filter. (*unless otherwise notified with a oil service message) 12,500 Miles (20,000km)* 9