GETTING TO KNOW YOUR VEHICLE 45 3. Push the programmed HomeLink® button to confirm that the garage door opener motor operates. If the garage door opener motor does not operate, repeat the final steps for the rolling code procedure. P ROGRAMMING H OME L INK ® T O A M ISCELLANEOUS D EVICE 1. Place the ignition in the ON/RUN position, without starting the engine. 2. Push and hold the desired HomeLink® button until the HomeLink® Indicator light begins to flash after 20 seconds. Do not release the button. The procedure on how to program HomeLink® to a miscellaneous device follows the same procedure as programming to a garage door opener Ъ page44.
Be sure to determine if the device has a rolling code, or non-rolling code before beginning the programming process. Non-Rolling Code Garage Door Opener Final Steps 3. Without releasing the button, proceed with Step 2in “Programming HomeLink® To A Garage Door Opener” Ъ page44, and follow all remaining steps. 2 1. Push and hold the programmed HomeLink® button and observe the HomeLink® indicator light. If the HomeLink® indicator light stays on constantly, programming is complete. NOTE: Canadian radio frequency laws require transmitter signals to time-out (or quit) after several seconds of transmission, which may not be long enough for HomeLink® to pick up the signal during programming.
Similar to this Canadian law, some U.S. gate operators are designed to time-out in the same manner. The procedure may need to be performed multiple times to successfully pair the device to your HomeLink® buttons. R EPROGRAMMING A S INGLE H OME L INK ® B UTTON 2. Push the programmed HomeLink® button to confirm that the garage door opener motor operates. If the garage door opener motor does not operate, repeat the steps from the beginning. C ANADIAN /G ATE O PERATOR P ROGRAMMING For programming transmitters in Canada/United States that require the transmitter signals to “time-out” after several seconds of transmission.
Your motorized door or gate will open and close while you are programming the universal trans ceiver. Do not program the transceiver if people or pets are in the path of the door or gate. WARNING! Canadian radio frequency laws require transmitter signals to time-out (or quit) after several seconds of transmission – which may not be long enough for HomeLink® to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to time-out in the same manner. To reprogram a single HomeLink® button that has been previously trained, without erasing all the channels, refer to the following procedure.
Be sure to determine whether the new device you want to program the HomeLink® button to has a rolling code, or non-rolling code. Do not run your vehicle in a closed garage or confined area while programming the trans ceiver. Exhaust gas from your vehicle contains Carbon Monoxide (CO) which is odorless and colorless. Carbon Monoxide is poisonous when inhaled and can cause you and others to be severely injured or killed. It may be helpful to unplug the device during the cycling process to prevent possible overheating of the garage door or gate motor.