CLAAS LEXION 500 series (520, 570) — Module A66 - GPS pilot module (GPB)

Electric System LEXION 500 TIC Description of function: 2/2 Concave display Sensor (B30) receives the necessary 12 V reference voltage from the power supply relay K52. The speed monitor module (A12) converts the analogue signal from sensor (B30) into a digital signal which is displayed on terminal (A30) via the CAN bus. Concave pressurising (hydro-pneumatic overload system) In order to avoid threshing drum blocking in case of threshing mechanism overload, the concave is pressurised hydraulically to 130 bar by an accumulator. The adjustment of this hydraulic pressurisation is by the concave overload system shut-off valve (636) – Hydraulic system, chapter 3.

Reducing the pressurisation Opening the shut-off valve (636) relieves the system pressure to the tank - the pressure falls. Increasing the pressurisation Opening the shut-off valve (636) in connection with actuating the Fill accumulator switch (U26) will increase the system pressure. Actuating the Fill accumulator switch (U26) is necessary to achieve a pressure build-up in the hydraulic system. After opening the concave overload system shut- off valve (636), this pressure goes into the accumulator and thus pressurises the concave hydraulically. Note: The pressurisation pressure of the hydro-pneumatic overload protection must be set to 130 bar. 08a-4 Lex-e-08a 03/05