CLAAS LEXION 500 series (520, 570) — Module A66 - GPS pilot module (GPB)

Electric System LEXION 500 TIC Description of function: 2/2 Reverse front attachment The front attachment must not be engaged as a pre-condition for the reversing function. The speed monitor module (A12) connects voltage to the reverse switch (S57) as an additional safety feature only after the feed rake conveyor speed sensor (B12) stops transmitting a signal for approx. 2 seconds. If these pre-conditions are met, voltage is connected from the speed monitor module (A12) to solenoid coil (Y86) via the reverse switch (S57) – Front attachment reverse function.

The master valve (Y77) is actuated via the diode PCB (DO) in parallel with the solenoid coil (Y86) because this function requires that pressure is built up in the system. Important! When the reversing function is active, a signal is connected to the reel module (A16) which makes the reel drive variable displacement pump swing to maximum delivery, depending on the front attachment identification – circuit diagram 22. Seat contact circuit After leaving the operator's seat, all circuits depending on the seat contact are interrupted after approx. 5 seconds. 17a-4 Lex-e-17a 03/05