TIC LEXION 500 Electric System Description of function: Front attachment variable- speed drive When the threshing mechanism is engaged, a CAN bus signal is transmitted to the speed monitor module (DZW) A12 by the +/- pushbuttons (T19/T26) provided that the function pre-selection rotary switch (T11) is set to the threshing drum position. The speed monitor module A12 controls the corresponding solenoid coils (Y89/Y90). The master valve (Y77) is also actuated via the diode PCB (DO) in parallel with the front attachment variable-speed drive fast solenoid coil (Y90) because this function requires that pressure is built up in the system.
Front attachment speed display The speed monitor module (A12) converts the analogue signal from the feed rake conveyor speed sensor (B12) into a digital signal which is displayed on terminal (A30) via the CAN bus. 03/05 Lex-e-18a 18a-3