CLAAS LEXION 500 series (520, 570) — 21b - Reel adjustment - VARIO cutterbar

TIC LEXION 500 Electric System Description of function: Reel adjustment When the road travel circuit is unlocked, the relays K1, K2, K3, and K4 are supplied with voltage on pin 30 and pin 86. The corresponding pushbutton (S37a/b/c/d) controls the relay K1, K2, K3 or K4 and thus the respective solenoid coil (Y22/Y23/Y24/25). The master valve (Y77) is also actuated via the diode PCB (DO) in parallel with one of the solenoid coils (Y22/Y24/25) because this function requires that pressure is built up in the system.

When activating the automatic cutterbar function on machines equipped with CEBIS, the automatic reel controller module (A16) ensures actuation of the reel height whereas the VARIO module (A27) is responsible for adjusting the cutting table and the reel horizontally. In this process, the settings in the terminal (A30) are compared to the actual values of the sensors (B39/B40/B70) and/or of the potentiometers (R11/R12/R30). The limit switch (Z64) ensures that the reel will never collide vertically with the cutting table and/or will not lower onto the knife. On the V-belt spring tensioner, the limit switch (Z64) avoids that the rape position is selected when the V-belt is installed.

03/05 Lex-e-21b 21b-3