TIC LEXION 500 Electric System Description of function: Reel adjustment When the road travel circuit is unlocked, the relays K1, K2, K3, and K4 are supplied with voltage on pin 30 and pin 86. The corresponding pushbutton (S37a/b/c/d) controls the relay K1, K2, K3 or K4 and thus the respective solenoid coil (Y22/Y23/Y24/25). The master valve (Y77) is also actuated via the diode PCB (DO) in parallel with one of the solenoid coils (Y22/Y24/25) because this function requires that pressure is built up in the system.
If the automatic cutterbar system is activated on machines equipped with CEBIS, the automatic reel controller module (A16) ensures actuation of the solenoid coils (Y22/Y23) and control of the master valve (Y77). In the process, the setting for the reel height in the terminal (A30) is compared to the actual value of the sensor (B39) (see also diagram 24). Important! An automatic function for horizontal reel adjustment is available only for VARIO cutterbars (see also diagram 21b). Important! The cutterbar can be folded only after the reel rear end position limit switch (Z14) has been actuated – circuit diagram 23a. 03/05 Lex-e-21c 21c-3