CLAAS LEXION 500 series (520, 570) — 26t - Machine monitor, Montana 570-520 - with integrated MONTANA control unit (from serial no. 581 00027 to 581 00037)

Key to diagram:

Coordinates A10 Fieldwork computer module (BIF/CAB)...............................2-i-20 A42 MONTANA GEN II module .................................................3-h-17 B123 Hydraulic oil temperature sensor........................................3-p-19 B127 Ground drive hydraulics metal detector sensor..................7-q-18 DI Warning device diode PCB..................................................4-i-20 K52 Power supply relay ..............................................................4-i-20 K56 Electronic unit plus relay......................................................4-i-20 X13 3D / rear axle connector .....................................................6-p-16 Z19 Hydraulic oil level actual value switch (min.) ......................3-p-19 Z20 Hydraulic oil temperature actual value switch ....................3-p-19 Z38 Left steering position actual value switch ...........................7-q-20 Z39 Right steering position actual value switch.........................7-q-16 Z46 Low-pressure hydraulics/ground drive oil pressure actual value switch..............................................................3-p-19 Z61 Straw jam warning actual value switch...............................3-s-18 Z78 Ground drive filter actual value switch................................3-o-19 Z79 Left brake circuit pressure switch .......................................5-g-20 Z80 Right brake circuit pressure switch ....................................5-g-20 Z84 Left brake pedal actual value switch....................................5-f-20 Z85 Right brake pedal actual value switch .................................5-f-20 a - Switch or sensor, depending on equipment fitted Z79 Z80 Pressure switch 115 bar Approx.

6V (U Bat /2) (at module input) NC contact, 50% PWM (T signal) Z84 Z85 Pressure switch 25 bar Approx. 6V (U Bat /2) (at module input) NO contact, 50% PWM (T signal) Z78 Pressure switch > 1250 Ω Ω Not actuated Actuated Measured value table: Item Component Measured value Remark B123 Sensor 12 V Signal = Earth (Pin 1-3) (Pin 2) Electric System LEXION Montana 570-520 TIC 26t-2 Lex-e-26t 03/05 26t Machine monitor, Montana 570-520 - with integrated MONTANA control unit (from serial no. 581 00027 to 581 00037) Item Component Measured value Remark B123 Sensor 12 V Signal = Earth (Pin 1-3) (Pin 2) Z78 Pressure switch > 1250Ω Not actuated Actuated Z79 Z80 Pressure switch 115 bar Approx.

6V (U /2) Bat (at module input) NC contact, 50% PWM (T signal) Z84 Z85 Pressure switch 25 bar Approx. 6V (U /2) Bat (at module input) NO contact, 50% PWM (T signal)