Electric System LEXION 500 TIC Description of function: Laser system function The laser beam emitted from the unit is reflected about 14 m ahead of the machine and received by the second optical system. Using the difference between the travel time of the signal between standing crop and stubbles, an edge is identified on which the machine is steered. The alignment of the laser pilot in the field is by means of a manually cut edge of standing crop. In this process, the unit is adjusted both vertically (V) and horizontally (H) until the two inside LEDs of the corresponding LED band light up in the cross-hairs (F).
Sensor identification Sensor / laser left/right By starting the menu item "Front attachment learn" in terminal A30, the type of sensor is automatically identified (sensor or laser system). Any other terminals (e.g. GPS-controlled steering) must be switched off during learning. Setting in terminal The basic setting of the Autopilot system (straight ahead travel, sensitivity, front attachment sensor zero point) is performed in the CEBIS terminal in the "Tachometer" sub-menu. 28a-4 Lex-e-28a 03/05